Service Bulletins

Lubrication, Highway 8.5.2009

Control of the slack adjuster yoke pin hole 28.11.2008/S18003

Axle final ratios related to the hub ratios in the 13/16 ton rigid drive planetary axles 1.10.2008/S16002

Improvement for the wheel rim attaching 6.2.2008/S18001

Change in the differentials in the 13/16 ton rigid drive axles 5.6.2007/S16001B

Retrofit rigid through shaft for replacing the inter-axle differential in FRMP13/16 S axles 30.3.2007/S17001

Grease nipple removal from the drive flange seal housing 18.1.2007/S14001

Replacing SBT slack adjusters with haldex slack adjusters 24.11.2006/S16003

King pin and wheel hub bearing wear limits for FSND10P disc brake 10 ton front axle 28.10.2005/S15001

Removing and installing the wheel hubs with the tight hub bearing fittings 1.7.2005/S13001

Change in the wheel studs 20.2.2004/S11006

Change in the brake shoe anchor pin in s-cam brakes 11.11.2002/S10006

Change in wheel hub sealing 7.11.2002/S12001B

Instructions for changing the axle breather position in FRMP-10/11 axles 13.6.2002/S12003

Change in sealing of king pins and axle shafts in FSDP14, FSFP14, FSFN14 and FSND12 axles 9.1.2002/S11002

Change in the pinion bearing in FRMP13/16 and FSMP14 axles with MP330 drive gears 28.9.2001/S11004

Change in the wheel nut (M22X1.5) tightening torque 12.6.2001/S11003

Change in locking the planet gear shafts 3.4.2001/S11001

Spacer rings added between the wheel hub bearings in hub reduction rear axles 22.1.2001/S9005C

Temporary input shaft seal in FRDP13/16, FSDP14, SRDP30, SSDP12 axles 29.12.2000/S10007

Change in installing the metal case type wheel hub seals 26.9.2000/S10005

Change in the oil filling plug in the tandem drive gear MP330 7.9.2000/S10004

Change in the oil filling plug in the tridem drive gear FP330 18.5.2000/S10003

Change in the drain plug on drive axles 16.5.2000/S10002

Adjusting instructions for the tie rod adjusting piece of later design for the FSDP-09/10 and SSDP-10/12 drive steer axles 22.3.2000/S10001